DNTBENV3 - Dynotest Mileage Blocker Bentley Flying Spur II (32 PIN) 2019-2021
DNTBENV3 - Dynotest Mileage Blocker Bentley Flying Spur II (32 PIN) 2019-2021
DNTBENV3 - Dynotest Mileage Blocker Bentley Flying Spur II (32 PIN) 2019-2021
DNTBENV3 - Dynotest Mileage Blocker Bentley Flying Spur II (32 PIN) 2019-2021
DNTBENV3 - Dynotest Mileage Blocker Bentley Flying Spur II (32 PIN) 2019-2021
DNTBENV3 - Dynotest Mileage Blocker Bentley Flying Spur II (32 PIN) 2019-2021

DNTBENV3 - Dynotest Mileage Blocker Bentley Flying Spur II (32 PIN) 2019-2021

 

Product Information

SKU:

DNTBENV3 

This device is specifically designed for testing Bentley Flying Spur II (32 PIN)) cars.
It provides the capability to temporarily suspend (freeze) the odometer during car testing, preventing the accumulation of additional mileage.

Flying Spur II car has 2 types of connectors: 32 PIN and 18 PIN.

This device is designed for a 32 PIN connector.


For more information, please visit the official product website: Dynotest

Device:
It is not intended to be used on public roads.
It is not intended for registered cars.

The Plug&Play technology eliminates the need for soldering during installation.

Information about the operation modes of the device on Bentley Flying Spur II (32 PIN): 
The hazard warning light on the dashboard will blink each time when the device switches between modes.

Mode 1

Press the "OK" button or pull HIGH BEAM lever 4 times.

The hazard warning light will blink once.

The mileage block function will be not active.

Speedometer will show the actual speed.

Mode 2

Press the "OK" button or pull HIGH BEAM lever 4 times.

The hazard warning light will blink twice.

The odometer will register 50 km for every 100 km driven.

Speedometer will show the actual speed.

Mode 3

Press the "OK" button or pull HIGH BEAM lever 4 times.

The hazard warning light will blink three times.

The odometer will register 10 km for every 100 km driven.

Speedometer will show the actual speed.

Mode 4

Press the "OK" button or pull HIGH BEAM lever 4 times.

The hazard warning light will blink four times.

The odometer will register 2 km for every 100 km driven.

Speedometer will show the actual speed.

Important for successful installation and use:

  • During device connection/disconnection, the ignition must be turned off
  • Switching between modes should be done on a stationary car
  • When the device is in use, the selected mode will be retained (saved) after the ignition is turned off/on

Other, alternative product names searched for:

Mileage Blocker, Mileage Stopper, Odometer Stopper, Odometer Blocker, Mileage Correction, CAN Filter, CAN Blocker, Mileage Freezer, Odometer Freezer, CAN Freezer.

No reviews

1 other product in the same category:

Viewed products

Product added to wishlist