Product Information

SKU: 

TLEF 

Toyota Flasher, a joint project of Autokey and PCMflash, is a multifunctional programmer for Denso and Fujitsu Ten ECUs with NEC processors installed in TOYOTA, LEXUS and SCION vehicles with petrol and diesel engines via JTAG interface. OBD writing via CAN bus is supported.

This is a unique solution in the world of chip tuning. It covers almost all models starting from 2003-2004. It can read, flash, clear, verify internal flash memory of microcontrollers if it is connected to the appropriate connector on the ECU PCB.

Supported ECUs:

All ECUs with the following NEC 7F00XX processors: 76F0038, 7F0038A, 76F0039, 76F0039A, 76F0040, 76F0040A, 76F0070 BGA, 76F0085 BGA.

These processors were introduced at the beginning of CAN support and, as a rule, with the change of bodywork.

Advantages:

Proprietary hardware interface allows you to avoid any compatibility and driver problems;

Work via the built-in 20 or 26 pin JTAG connector;

Full access to ECU memory at high speed over 100 KB/s;

Saving files in an open format;

Verification and recalculation of the firmware checksum.

SUPPORT 2015 + OBD WRITE

and

SOME MODELS 2015 + OBD READ

and

GEN_2 CAN-BUS RECOVERY MODE

can READ and WRITE via internal 20 pin or 26 pin connector.

connection diagram for all known pcb you can find here :

CONNECTION DIAGRAM PDFs

SUPPORTED DEVICES :

TOYOTA DENSO ENGINE CONTROL MODULE

based on NEC 7F00XX series MCU

76F0038

7F0038A

76F0039

76F0039A

76F0040

76F0040A

76F0070 BGA

76F0085 BGA

76F0086 BGA

Saving in normal mode  without any master-slave. Master only.

auto CHECKSUM CORRECTION support

Attention!

DO NOT USE external 12V power for programmer if connect to car OBD connector!!!

use USB powering ONLY !!!

Software version 1.19

 Download (474.08KB)